Xhorse.co.uk Technical Support
Xhorse Dolphin XP-005 has released an upgrade to fix a common problem. That’s when cutting the single-sided Toyota emergency key on the M2 clamp with a shim, it’ll pop the key out no matter how hard you tighten it. It’s super frustrating. Now I’ll show how to do it with the M1 clamp, which is mainly used on side cut keys. Connect VVDI Key Tool Max Pro to the Dolphin machine. Cut by bittingRead More…
This is a tutorial on how to read and write Microcontrollers with XHORSE Multi-Prog Programmer. Read this article to learn the procedure. 1. Check Model Check the model of the microcontroller, and open Multi-Prog software. Click “Device” to enter the model number: ATMEGA32 Click “Details”, and we can see the device info, important info, and adapter info. And now we learn that the microcontrRead More…
This post will guide you on how to use Xhorse Multi-prog Programmer to read and write EEPROM. First, we check the model of the EEPROM. Then we open the Multi-prog software. Click “Device”>>”Serial EEPROM&FLASH”, and enter the model number. Open the “Details” and you can see the device information, important prompt, and adapter information. Now we learn Read More…
Problem: Hello, I have a situation with a Mercedes Vito W639 2008. Only 1 key stopped starting, remote is still working. I checked with VVDI MB BGA Tool, see screens. Can I program a new key on bench or do more diagnostics? Very thanks. VVDI MB Tool gave the attention: “EIS is not synchronized with the current key!!! Maybe the key is not working key or EIS lost data!!! If the key can not finiRead More…
Problem: The Xhorse MVCI PRO J2534 Cable is connected to the car. But when starting the Audi diagnostics, it will immediately shut down and start flashing red and green even though all the firmware has been updated. The option to test the cable in software doesn’t even work. It prompted:” Command timeout! Close other J2534 software, plug the device, upgrade firmware, and retry!” What’s the pRead More…
Today I’ll show how to use Xhorse Multi-Prog Programmer to read & write VW Bosch EDC16/EDC17 on bench. Connect Bosch EDC16 to Xhorse Multi-Prog according to the wiring diagram. EXT EEPROM >> Read It took the 40s to read the EEPROM… Read success. EXT FLASH >> Read It took 2 minutes and 14s to read the external flash. Read success. INT FLASH >> Read IRead More…
