Xhorse.co.uk Technical Support
Hey everyone, let me walk you through an ECU cloning job I just wrapped up using the Xhorse Multi Prog. A customer dropped off two modules – one original, and a used one from eBay – and asked me to copy the data from the original to the replacement. No complicated instructions, just a straightforward clone. Here’s how it went. Step1. Connect First, I hooked up the original ECU. The Multi-Prog Read More…
This tutorial will guide you through using the Xhorse Audi BCM2 Solder-Free Adapter to read vehicle D-flash and P-flash memory and calculate IMMO data. The new version adapter supports all BCM2 series modules. Preparation Identify the correct adapter (Adapter A or Adapter B) for your BCM2 module Prepare VVDI Key Tool Plus or Multi-Prog Programmer Verify adapter pin alignment witRead More…
Problem: The XHORSE Multi-Prog Programmer screen is blank without a menu. I can’t perform any functions. What’s wrong with it? Please help. Solution Follow the below to disassemble Multi-Prog device: 1) Remove 6 screws on the back. 2) Remove all screws on the side. 3) Remove in the direction of the arrow. 4) Disconnect and reconnect all wires to the device. IRead More…
Customer Question: I just received the Xhorse Multi Prog, and this problem occurs when I turn it on. How can I solve it? Solution: Disassemble the screws and nuts indicated by the red circle according to the picture below: Finally, refer to the picture below to disconnect the cable pointed by the arrow and reconnect it. www.xhorsetool.co.ukRead More…
Problem: Why the XHORSE Multi-Prog Software prompt: “Not connect to the device, please check and try again!” What’s the reason? Am I misconnecting? Please help. Solution 1. Check if the device connection is correct. 2. Check if the driver was installed successfully. In general, the Multi-Prog driver will automatically install with software. If not, please install it manually. HeRead More…
